GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Oldsmobile 🢒 1998 🢒 Intrigue 🢒 Body and Accessories 🢒 Instrument Panel, Gauges, and Console 🢒 Front Floor Console Trim Plate Replacement

Removal Procedure

    Object Number: 289504 Size: SH
  1. Open the front floor console storage compartment door.
  2. Ensure that the front cup holder is in the open position.
  3. Remove the bolts retaining the front floor console trim plate.
  4. Carefully lift to release the console trim plate.
  5. Disconnect the electrical connector from the traction control switch.

    6. Object Number: 182735 Size: SH
  6. Depress the retaining tabs on the underside of the traction control switch, then remove the switch from the trim plate.

Installation Procedure

    Object Number: 182735 Size: SH
  1. Align the traction control switch to the front floor console trim plate, then press into place to secure.

    2. Object Number: 289504 Size: SH
  2. Connect the electrical connector to the traction control switch.
  3. Install the console trim plate to the console.

    4. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  4. Install the front floor console trim plate retaining screws.

    5. Tighten
    Tighten the front floor console trim plate retaining screws to 2 N·m (18 lb in).

  5. Close the front cup holder.
  6. Close the front floor console storage compartment door.