Removal Procedure
- Open the rear compartment lid.
- Remove the nuts retaining the remote compact disc (CD) player mounting bracket, then reposition the mounting bracket.
- Disconnect the electrical/audio connector from the remote CD player.
- Remove the bolts retaining the remote CD player to the mounting bracket.
- Remove the remote CD player from the mounting bracket.
- If shipping or transporting the remote CD player, reinstall the transportation pin by inserting the pin into the original position and fixing in place with clear tape.
Important: Reinstall the transportation pin when shipping or transporting the remote CD player.
Installation Procedure
- Remove the transportation pin from the remote compact disc (CD) player, if installed prior.
- Align and insert the remote CD player into the mounting bracket.
- Install the remote CD player to mounting bracket retaining bolts.
- Connect the electrical/audio connector to the remote CD player.
- Position the remote CD player mounting bracket onto the mounting studs in the rear compartment.
- Install the remote CD player mounting bracket retaining nuts.
- Close the rear compartment lid.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the remote CD player to mounting bracket retaining bolts to
2 N·m (18 lb in).
Tighten
Tighten the remote CD player mounting bracket retaining nuts to 7 N·m
(62 lb in).
