Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Was the Wiper/Washer System Check performed? | -- | Go to Step 2 | |
2 |
Is the measurement greater than the specified value? | 1.0 V | Go to Step 6 | Go to Step 3 |
3 | Check for a poor connection at connector C203, or for an open circuit in the pigtail to the wiper/washer switch. Is a poor connection or an open circuit present? | -- | Go to Step 5 | Go to Step 4 |
4 | Replace the wiper/washer switch. Refer to Turn Signal and Multifunction Switch Assembly - Off Vehicle . Is the replacement complete? | -- | -- | |
5 | Repair the poor connection or the open circuit conditon. Is the repair complete? | -- | -- | |
6 |
Is the measurement greater than the specified value? | 1.0 V | Go to Step 8 | Go to Step 7 |
7 | Repair the open circuit in CKT 113. Is the repair complete? | -- | -- | |
8 | Measure the voltage by backprobing from the wiper/washer switch connector C203, terminal A to ground, using a J 39200 . Is the measurement greater than the specified value? | 1.0 V | Go to Step 11 | Go to Step 9 |
9 | Check for a poor connection at connector C203, or for an open circuit in the pigtail to the wiper/washer switch. Is a poor connection or open circuit present? | -- | Go to Step 5 | Go to Step 10 |
10 | Replace the wiper/washer switch. Refer to Turn Signal and Multifunction Switch Assembly - Off Vehicle . Is the replacement complete? | -- | -- | |
11 | Measure the voltage from the wiper motor connector, terminal E to ground, using a J 39200 . Is the measurement greater than the specified value? | 1.0 V | Go to Step 13 | Go to Step 12 |
12 | Repair the open circuit in CKT 112. Is the repair complete? | -- | -- | |
13 | Replace the wiper motor cover. Refer to Wiper Motor Cover Replacement . Is the replacement complete? | -- | -- |
