Seat Belt Retractor Replacement - Left Front new

1. Open the seat belt guide loop cover.
2. Remove the guide loop nut.
3. Remove the guide loop from the guide adjuster bracket.
4. Remove the lower center pillar trim. Refer to Center Pillar Lower Trim Panel Replacement in Interior Trim.



5. Remove the intermediate guide bolts.



6. Remove the anchor plate nut from the seat stud.
7. Remove the anchor plate from the seat stud.



8. Remove the seat belt retractor bolt.
9. Remove the seat belt retractor from the lower center pillar.

1. Install the seat belt retractor into the T-slot in the lower center pillar.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the seat belt retractor bolt.

Tighten
Tighten the seat belt retractor bolt to 42 N·m (31 lb ft).




3. Position the anchor plate to the seat stud.
4. Install the anchor plate nut to the seat stud.

Tighten
Tighten the anchor plate nut to 42 N·m (31 lb ft).




5. Install the intermediate guide bolts.

Tighten
Tighten the intermediate guide bolts to 10 N·m (89 lb in).

6. Install the lower center pillar trim. Refer to Center Pillar Lower Trim Panel Replacement in Interior Trim.



7. Position the guide loop to the guide adjuster bracket.
8. Install the guide loop nut.

Tighten
Tighten the guide loop nut to 42 N·m (31 lb ft).

9. Close the guide loop cover.