GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Oldsmobile 🢒 1998 🢒 Intrigue 🢒 Suspension 🢒 Rear Suspension 🢒 Stabilizer Shaft Link Shield Replacement

Removal Procedure
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.

    2. Object Number: 156945 Size: SH
  2. Disconnect the rear stabilizer shaft link (2) from the stabilizer shaft (3).
  3. Remove the rear stabilizer shaft shield (1) from the rear stabilizer shaft end (3).

Installation Procedure

    Object Number: 156945 Size: SH
  1. Install the rear stabilizer shaft shield (1) to the rear stabilizer shaft end (3).

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Connect the rear stabilizer shaft link (2) to the rear stabilizer shaft (3).

    3. Tighten
    Tighten the stabilizer shaft link nut to 35 N·m (26 lb ft).

  3. Lower the vehicle.