Use only double-wrapped and use only brazed steel pipe meeting the GM specification 123M or equivalent if replacement of the transaxle oil cooler pipes are required. Ensure the pipe is double-flared.

Notice: Allow sufficient clearance around the transaxle oil cooler pipes and around the hoses to prevent damage or wear which may cause fluid loss.

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Position the drain pan.
3. Remove the transaxle oil cooler hoses from the pipes. Refer to Automatic Transmission Oil Cooler Hose Replacement .



4. Remove the transaxle oil cooler pipe fittings at the radiator.
5. Remove the transaxle oil cooler pipe retainer bolt/screw.
6. Remove the transaxle oil cooler pipes.

Important: The correct thread engagement is critical. Crossthreaded fittings can achieve proper tightness value and still leak.

1. Install the transaxle oil cooler pipes.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the transaxle oil cooler pipe retainer bolt/screw.

Tighten
Tighten the transaxle oil cooler pipe retainer bolt/screw to 4 N·m (27 lb in).

3. Install the transaxle oil cooler pipe fittings at the radiator.

Tighten
Tighten the transaxle oil cooler pipe fittings to 45 N·m (33 lb ft).

4. Install the transaxle oil cooler hoses to the pipes. Refer to Automatic Transmission Oil Cooler Hose Replacement .
5. Lower the vehicle.
6. Adjust the fluid level. Refer to the following information:

•	Transmission Fluid Check

•	Approximate Fluid Capacities in Maintenance and Lubrication

•	Fluid and Lubricant Recommendations in Maintenance and Lubrication

7. Inspect for fluid leaks and repair as necessary.