GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Oldsmobile 🢒 1998 🢒 Intrigue 🢒 Engine 🢒 Engine Mechanical - 3.8L 🢒 Brake Pedal Replacement

Removal Procedure
  1. Remove the driver's side instrument panel insulator. Refer to Instrument Panel Insulator Replacement in Instrument Panel, Gauges and Console.
  2. Remove the stoplamp switch. Refer to Stop Lamp Switch Replacement .
  3. Remove the cruise control release switch (if equipped). Refer to Cruise Control Release Switch Replacement in Cruise Control.
  4. Remove the Body Control Module for clearance. Refer to Body Control Module Replacement in Body Control System.
  5. Remove the wiring harness clips.

    6. Object Number: 179276 Size: SH
  6. Remove the master cylinder pushrod retaining clip at the brake pedal.

    7. Object Number: 347315 Size: SH
  7. Remove the brake pedal mounting nut (10) and bolt (9) on the top and back of the brake pedal bracket.
  8. Remove the brake pedal (7) and bushings (4), if necessary.
  9. Clean all the parts with a suitable solvent.
  10. Inspect all the parts for wear. Repair or replace any damaged parts.

Installation Procedure

    Object Number: 347315 Size: SH
  1. Install the brake pedal (7) and bushings (4), if removed. Lubricate the bushings with white lithium grease.

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the brake pedal mounting nut (10) and bolt (9).

    3. Tighten
    Tighten the brake pedal mounting nut and bolt to 40 N·m(30 lb ft).


    Object Number: 179276 Size: SH
  3. Install the master cylinder pushrod retaining clip at the brake pedal.
  4. Install the wiring harness clips.
  5. Install the Body Control Module. Refer to Body Control Module Replacement in Body Control System.
  6. Install the cruise control release switch (if equipped). Refer to Cruise Control Release Switch Replacement in Cruise Control.
  7. Install the stoplamp switch. Refer to Stop Lamp Switch Replacement .
  8. Install the driver's side instrument panel insulator. Refer to Instrument Panel Insulator Replacement in instrument Panel, Gauges and Console.