GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Oldsmobile 🢒 1999 🢒 Eighty Eight 🢒 Suspension 🢒 Front Suspension 🢒 Stabilizer Shaft Insulator Replacement

Removal Procedure

    Object Number: 155689 Size: SH
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the stabilizer shaft clamp bolts.
  3. Remove the stabilizer shaft clamp.
  4. Remove the stabilizer shaft rubber insulator.

Installation Procedure

    Object Number: 155689 Size: SH
  1. Install the stabilizer shaft rubber insulator.
  2. Install the stabilizer shaft clamp.

    3. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the stabilizer clamp bolts.

    4. Tighten
    Tighten the stabilizer clamp bolts to 47 N·m (35 lb ft).

  4. Lower the vehicle.