Removal Procedure
- Remove the loosening screw at the rearview mirror support.
- Disconnect the electrical connector, if equipped.
- Slide the rearview mirror
from the rearview mirror support.
- Remove and retain the reading lamp bulbs, if equipped. Pry lens
off with a flat bladed too to access bulb.
Installation Procedure
- Install the reading lamp bulb to the socket, if equipped.
- Install the lens. Ensure that the unit is retained.
- Locate the rearview mirror
support on the windshield.
- Install the rearview mirror to the rearview mirror support, ensuring
that the mirror is fully seated.
- Connect the electrical connector, if equipped.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the screw
at the rearview mirror support.
Tighten
Tighten the screw to 2 N·m (18 lb in).