A Class Il serial data communications system is used on this vehicle to allow various modules to communicate and share information with each other. Each bit of information has one of two lengths: long or short. This allows vehicle wiring to be reduced and the transmission and reception of multiple signals over a single wire. The messages carried on a Class II serial data streams are also prioritized. If two messages attempt to establish communications on the data line at the same time, the message with the higher priority will continue. The message with the lower priority message will wait. If a module cannot respond to the PCM, a DTC is stored.

The PCM cannot communicate with the EBCM.

Attempting to start the vehicle by bypassing the theft deterrent system or substituting parts without performing the password learn procedure may set a DTC P1630 and P1631.

If no password is received a DTC P1610, P1626 and P1631 may be set.

An intermittent may be caused by a poor connection, rubbed through wire insulation or a wire broken inside the insulation.

Any circuitry, that is suspected as causing an intermittent complaint, should be thoroughly checked for the following items:

Numbers below refer to the step numbers on the Diagnostic Table:

1. The Powertrain OBD System Check prompts the technician to complete some basic checks and store the freeze frame and failure records data on the scan tool if applicable. This creates an electronic copy of the data taken when the fault occurred. The information is then stored in the scan tool for later reference.

2. A scan tool that cannot display PCM data indicates that a short, or open may exist on the serial data circuit. Refer to Data Link Connector .

4. An intermittent short on the BFC serial data circuit could cause this DTC to set. When the fault is present, the scan tool will lose communication with the PCM. Check for chaffed wiring or a faulty BFC module.

5. The DTC is intermittent when a scan tool can communicate with the PCM. DTCs with other modules may lead to a possible cause of the intermittent problem.

   If the serial data loss occurred after a good theft password has been received, the PCM must be reprogrammed and the password learn and the crankshaft position variation learn procedures must be completed to allow the theft system to operate properly. Refer to Powertrain Control Module Replacement/Programming , Crankshaft Position System Variation Learn and Password Learn Procedure for reprogramming procedures.

7. If no malfunctions have been found at this point and no additional DTCs were set, refer to Diagnostic Aids for additional checks and information.