Test the lateral runout with the wheels still installed on the vehicle. This gives a much more accurate reading of the total indicated runout (TIR) under real braking conditions. If equipment is not available to perform the test with the wheels installed, obtain the next best reading with the wheels removed but with the caliper still installed.

1. Clean the rotor surface.

Important: If you remove the wheel, re-install the wheel nuts in order to retain the rotor. Tighten the wheel nuts to the correct tightening specification following the wheel nut tightening sequence. Refer to Wheel Removal in Tires and Wheels.

2. Fasten a dial indicator to the steering knuckle so that the indicator button contacts the rotor surface about 13 mm (0.5 in) from the outer edge.
3. Set the dial indicator to zero.

Notice: Whenever the brake rotor has been separated from the wheel bearing flange, clean any rust or foreign material from the mating surface of the wheel bearing flange and rotor. Failure to do this may result in increased lateral runout of the rotor and brake pulsation.

4. Turn the wheel one complete revolution and observe the runout indicated on the dial. The total indicated runout (TIR) must not exceed 0.04 mm (0.0015 in).

In some cases, excessive lateral runout of the rotor may be improved by indexing the rotor on the hub, 1 or 2 bolt positions from the original position. If you cannot correct the lateral runout by indexing the rotor, inspect the hub and bearing assembly for excessive lateral runout or looseness.