GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Oldsmobile 🢒 1998 🢒 Cutlass 🢒 Engine 🢒 Engine Mechanical - 3.1L and 3.4L 🢒 Exhaust Crossover Replacement

Removal Procedure
  1. Remove the air cleaner duct.

    2. Object Number: 63508 Size: SH
  2. Remove the heat shield bolts.
  3. Remove the heat shields.

    4. Object Number: 54282 Size: SH
  4. Remove the crossover pipe bolts.
  5. Remove the crossover pipe.

Installation Procedure

    Object Number: 54282 Size: SH
  1. Install the crossover pipe.

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the crossover bolts.

    3. Tighten
    Tighten the bolts to 25 N·m (18 lb ft).


    Object Number: 63508 Size: SH
  3. Install the heat shields.
  4. Install the heat shield bolts.

    5. Tighten
    Tighten the bolts to 10 N·m (89 lb in).

  5. Install the air cleaner duct.
  6. Inspect for exhaust leaks.