GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Oldsmobile 🢒 2003 🢒 Aurora 🢒 General Information 🢒 General Information 🢒 Front Fog Lamp Replacement

Replacement Procedure
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the air deflector. Refer to Front Air Deflector Replacement in Body Front End.

    3. Object Number: 313080 Size: SH
  3. Remove the fasteners securing the front fog lamp assembly to the front bumper fascia.
  4. Position the fog lamp forward in order to access the electrical connector.
  5. Disconnect the electrical connector from the front fog lamp assembly.
  6. Remove the fog lamp assembly.

Installation Procedure

    Object Number: 313080 Size: SH
  1. Connect the electrical connector to the fog lamp assembly.
  2. Install the fog lamp to the front bumper fascia.

    3. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the front fog lamp mounting fasteners.

    4. Tighten
    Tighten the front fog lamp mounting fasteners to 6 N·m (53 lb in).

  4. Install the air deflector. Refer to Front Air Deflector Replacement in Body Front End.
  5. Lower the vehicle.