Schematic Reference: Wiper/Washer Schematics

Connector End View Reference: Wiper/Washer Connector End Views

DEFINITION: The low washer fluid message is always displayed or does not display with low washer fluid.

Did you review the Wiper/Washer System Description and Operation and perform the necessary inspections?

Go to Step 2

Go to Symptoms - Wiper/Washer Systems

Verify the fault is present.

Does the system operate normally?

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step 3

1. Turn the ignition OFF.
2. Disconnect the washer fluid level switch connector.
3. Turn the ignition ON.

Is the low washer fluid message displayed on the driver information center?

Go to Step 6

Go to Step 4

1. Turn the ignition OFF.
2. Connect a fused jumper wire from the washer fluid level switch signal circuit terminal in the washer fluid level switch connector to a good ground.
3. Turn the ignition ON.

Is the low washer fluid message displayed on the driver information center?

Go to Step 5

Go to Step 7

1. Turn the ignition OFF.
2. Connect a fused jumper wire across the washer fluid level switch harness connector terminals.
3. Turn the ignition ON.

Is the low washer fluid message displayed on the driver information center?

Go to Step 9

Go to Step 8

Test the washer fluid level switch signal circuit for a short to ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 13

Go to Step 11

Test the washer fluid level switch signal circuit for an open or high resistance. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 13

Go to Step 11

Repair the washer fluid level switch ground circuit for an open or high resistance. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Is the repair complete?

Go to Step 13

--

Inspect for poor connections at the washer fluid level switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 13

Go to Step 10

Replace the washer fluid level switch. Refer to Windshield Washer Solvent Level Switch Replacement .

Is the repair complete?

Go to Step 13

--

Inspect for poor connections at the driver information center. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 13

Go to Step 12

Replace the driver information center. Refer to Driver Information Center Module Replacement in Instrument Panel, Gages, and Console.

Is the repair complete?

Go to Step 13

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 3