Circuit Description
The Ambient Air Temperature Sensor is a thermistor that controls signal voltage to the HVAC programmer. The HVAC programmer supplies voltage on CKT 735. When the sensor is cold, the resistance is high and the HVAC programmer will sense a high signal voltage at terminal B1. When the sensor warms, resistance is reduced and the signal voltage is pulled low through CKT 61. Signal voltage will vary from 5 V (open circuit) to 0 V (short circuit).
Conditions for Setting the DTC
| • | The ignition is ON. |
| • | Circuit open or shorted. |
Action Taken When the DTC Sets
| • | A blank is displayed on the drivers information center. |
| • | A default value of 15° C (59° F) will be used by the HVAC programmer to allow operation of the A/C system. |
Conditions for Clearing the DTC
| • | Using a Scan Tool |
| • | A history DTC will clear when 40 consecutive ignition cycles have occurred without a malfunction. |
| • | HVAC programmer battery voltage is interrupted. |
Test Description
Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 |
Refer to Sensor Resistance Table . Is the resistance within the specified range according to the table? | -- | Go to Step 3 | Go to Step 2 |
2 | Replace the sensor. Refer to Ambient Temperature Sensor Replacement . Is the repair complete? | -- | System OK | -- |
Refer to Measuring Voltage in Wiring Systems. Is the voltage approximately equal to the specified value? | 5 V | Go to Step 4 | Go to Step 8 | |
4 |
Does the DTC reset? | -- | Go to Step 5 | |
5 | Inspect all of the related connectors for proper terminal contact. Is the terminal contact correct? | -- | Go to Step 6 | Go to Step 7 |
6 | Replace the HVAC programmer. Refer to Programmer Replacement . Is the repair complete? | -- | System OK | -- |
7 | Correct the terminal contact. Refer to Repairing Connector Terminals in Wiring Systems. Is the repair complete? | -- | System OK | -- |
8 | Is the voltage greater than the specified value? | 5 V | Go to Step 9 | Go to Step 10 |
9 | Repair the short to the battery in CKT 735. Refer to Wiring Repairs in Wiring Systems. Is the repair complete? | -- | System OK | -- |
10 | Measure the voltage between sensor terminal A and the DLC terminal 4. Refer to Measuring Voltage in Wiring Systems. Is the voltage approximately equal to the specified value? | 5 V | Go to Step 14 | Go to Step 11 |
11 | Backprobe and measure the voltage between HVAC programmer terminal B1 and the DLC terminal 4. Refer to Measuring Voltage and Probing Electrical Connectors in Wiring Systems. Is the voltage approximately equal to the specified value? | 5 V | Go to Step 12 | Go to Step 13 |
12 | Repair the open in CKT 735. Refer to Wiring Repairs in Wiring Systems. Is the repair complete? | -- | System OK | -- |
13 | Replace the HVAC programmer. Refer to Programmer Replacement . Did you replace the programmer? | -- | System OK | -- |
14 | Are all of the sensor DTCs present? | -- | Go to Step 15 | Go to Step 17 |
15 | Inspect CKT 61 for opens. Is the circuit OK? | -- | Go to Step 16 | Go to Step 17 |
16 | Replace the HVAC programmer. Refer to Programmer Replacement . Is the repair complete? | -- | System OK | -- |
17 | Repair the open in CKT 61. Refer to Wiring Repairs in Wiring Systems. Is the repair complete? | -- | System OK | -- |
