For 1990-2009 cars only
Adjust the height of the sliding glass panel in the following manner:
| • | Equal in height from side-to-side |
| • | Front of the sliding glass panel (1), flush to 1.0 mm (0.040 in) below the roof panel (2) |
| • | Rear of the sliding glass panel, flush to 1.0 mm (0.040 in) above the roof panel |
| • | This provides the proper sealing and minimizes windnoise. |
With the sliding glass panel in the closed position, inspect the height of the glass panel at the following locations:
| • | The front of the glass panel |
| • | The rear of the glass panel |
If the panel height is not within the above specifications, perform the following adjustment procedure:
- With the glass panel fully closed, slide the sunshade fully rearward.
- Remove the 3 fasteners from the front edge of the shield ring. Slide the shield ring rearward.
- In order to adjust any corner, complete the following steps:
- After loosening the 2 fasteners, move the glass panel up or down by hand.
- Inspect the sliding glass panel height.
- Repeat the adjustment procedures on the other corners as needed in order to meet the height specifications.
- Slide the shield ring forward.
- Install the 3 retaining fasteners.
Important: Adjust the sliding glass panel height one corner at a time. Only adjust the corners that are not at the proper height. After adjusting each corner, inspect the height of the entire sliding glass panel in order to determine if additional adjustment is required.
Important: DO NOT loosen all 3 of the fasteners on the side being adjusted.
| 3.1. | Loosen the glass panel mounting fastener nearest to the corner being adjusted. |
| 3.2. | Loosen the center mounting fastener on the side being adjusted. |
Tighten the 2 fasteners.
Readjust the height as needed.
