Circuit Description
This DTC is designed to not allow a service PCM to be installed in a vehicle without first flashing software into it.
Conditions for Setting the DTC
Test Condition
Test continuously.
Failure Condition
No software data is present in PCM.
Action Taken When the DTC Sets
| • | Fuel pump is disabled. |
| • | Injector pulse width is set to 0. |
| • | Back-up fuel is disabled. |
| • | The PCM will illuminate the malfunction indicator lamp (MIL) when the diagnostic runs and fails. |
| • | The PCM will record operating conditions at the time the diagnostic fails. This information will be stored in the Freeze Frame and Failure Records. |
Conditions for Clearing the Message/DTC
| • | The PCM will turn the MIL OFF after three consecutive drive trips that the diagnostic runs and does not fail. |
| • | A Last Test Failed (current) DTC will clear when the diagnostic runs and does not fail. |
| • | A History DTC will clear after forty consecutive warm-up cycles with no failures of any emission related diagnostic test. |
| • | Use a scan tool to clear DTCs. |
| • | Interrupting PCM battery voltage may or may not clear DTCs. This practice is not recommended. Refer to Clearing Diagnostic Trouble Codes in PCM Description and Operation. |
Test Description
Number(s) below refer to the step number(s) on the Diagnostic Table.
-
Flashing the PCM with the correct software for the vehicle.
-
If flashing attempt fails the PCM is faulty.
Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Was the On-Board Diagnostic (OBD) System Check performed? | -- | Go to A Powertrain On Board Diagnostic (OBD) System Check | |
Flash the PCM with the correct software. Does DTC P0602 reset? | -- | Go to Powertrain Control Module Diagnosis for Verify Repair | ||
Replace the PCM. Refer to PCM Replacement/Programming . Is the replacement complete? | -- | Go to Powertrain Control Module Diagnosis for Verify Repair | -- |
