CROSS CAR WINDNOISE AT 'A' PILLAR

SUBJECT: CROSS CAR WINDNOISE AT "A" PILLAR ON FRONT DOORS (INSTALL FILLER PATCH)

MODELS: 1995 OLDSMOBILE AURORA

CONDITION:

SOME OWNERS MAY COMMENT ON A CROSS CAR WINDNOISE AT THE "A" PILLAR ON THE FRONT DOORS.

CAUSE:

CONDITION MAY BE CAUSED BY A GAP AT THE DOOR AND D-LINE MOLDING FILLER PATCH.

CORRECTION:

INSTALL A FILLER PATCH AT DOOR CAVITY USING THE FOLLOWING PROCEDURE:

1. CLEAN THE BONDING SURFACE WHERE FILLER PATCH IS TO BE INSTALLED WITH ISOPROPYL RUBBING ALCOHOL OR SIMILAR CLEANING SOLVENT.

2. INSTALL FILLER PATCH AT DOOR CAVITY AS SHOWN IN FIGURE 1, VIEW "A" AND FIGURE 2, VIEW "B".

IMPORTANT: FILLER PATCH MUST BE INSTALLED 5MM (13/64") INBOARD FOR PROPER INSTALLATION.

PARTS INFORMATION:

LEFT DOOR - P/N 25642779 RIGHT DOOR - P/N 25642780

PARTS ARE CURRENTLY AVAILABLE FROM GMSPO.

WARRANTY INFORMTATION:

FOR VEHICLES REPAIRED UNDER WARRANTY, USE:

LABOR OPERATION NUMBER: C1084 (RIGHT) C1085 (LEFT) LABOR TIME: 0.2 HR

FIGURES: 2 ATTACHMENTS: 0

GENERAL MOTORS BULLETINS ARE INTENDED FOR USE BY PROFESSIONAL TECHNICIANS, NOT A "DO-IT-YOURSELFER". THEY ARE WRITTEN TO INFORM THOSE TECHNICIANS OF CONDITIONS THAT MAY OCCUR ON SOME VEHICLES, OR TO PROVIDE INFORMATION THAT COULD ASSIST IN THE PROPER SERVICE OF A VEHICLE. PROPERLY TRAINED TECHNICIANS HAVE THE EQUIPMENT, TOOLS, SAFETY INSTRUCTIONS AND KNOW-HOW TO DO A JOB PROPERLY AND SAFELY. IF A CONDITION IS DESCRIBED, DO NOT ASSUME THAT THE BULLETIN APPLIES TO YOUR VEHICLE, OR THAT YOUR VEHICLE WILL HAVE THAT CONDITION. SEE A GENERAL MOTORS DEALER SERVICING YOUR BRAND OF GENERAL MOTORS VEHICLE FOR INFORMATION ON WHETHER YOUR VEHICLE MAY BENEFIT FROM THE INFORMATION.

COPYRIGHT 1995 GENERAL MOTORS CORPORATION. ALL RIGHTS RESERVED.