PLEASE REPLACE THE I/P CLUSTER REMOVAL AND INSTALLATION PROCEDURE IN SECTION 8C WITH THE FOLLOWING:
REMOVE OR DISCONNECT:
1. DISABLE SUPPLEMENTAL INFLATABLE RESTRAINT (SIR). REFER TO PROCEDURE IN SECTION 8C.
2. KNEE BOLSTER. REFER TO PROCEDURE IN SECTION 8C.
3. UPPER STEERING COLUMN BRACKET NUTS (2). REFER TO SECTION 3F, LOWER STEERING COLUMN.
4. TRUNK/FUEL DOOR RELEASE TRIM PLATE AND INTERIOR LAMP TRIM PLATE BY PULLING REARWARD. DISCONNECT ELECTRICAL CONNECTORS AS NECESSARY.
5. CENTER A/C OUTLET TRIM PANEL.
6. I/P CLUSTER TRIM PANEL, PULL DOWN AND REARWARD TO CLEAR UPPER I/P TRIM PAD.
7. SCREWS (5) FROM I/P CLUSTER.
8. UNPLUG TWO (2) ELECTRICAL CONNECTORS ON BACK OF I/P CLUSTER.
9. I/P CLUSTER FROM I/P ASSEMBLY.
INSTALL OR CONNECT:
1. I/P CLUSTER TO I/P ASSEMBLY.
2. TWO (2) ELECTRICAL CONNECTORS TO BACK OF I/P CLUSTER.
3. SCREWS (5) FROM I/P CLUSTER TO I/P ASSEMBLY.
4. STEERING COLUMN BRACKET NUTS (2), REFER TO SECTION 3F.
5. KNEE BOLSTER, REFER TO PROCEDURE IN SECTION 8C.
6. I/P CLUSTER TRIM PANEL.
7. CENTER A/C OUTLET TRIM PANEL.
8. TRUNK/FUEL DOOR RELEASE DOOR TRIM PLATE AND INTERIOR LAMP TRIM PLATE. CONNECT ELECTRICAL CONNECTORS AS NECESSARY.
9. ENABLE SIR, REFER TO PROCEDURE IN SECTION 8C.
FIGURES: 0
GENERAL MOTORS BULLETINS ARE INTENDED FOR USE BY PROFESSIONAL TECHNICIANS, NOT A "DO-IT-YOURSELFER". THEY ARE WRITTEN TO INFORM THOSE TECHNICIANS OF CONDITIONS THAT MAY OCCUR ON SOME VEHICLES, OR TO PROVIDE INFORMATION THAT COULD ASSIST IN THE PROPER SERVICE OF A VEHICLE. PROPERLY TRAINED TECHNICIANS HAVE THE EQUIPMENT, TOOLS, SAFETY INSTRUCTIONS AND KNOW-HOW TO DO A JOB PROPERLY AND SAFELY. IF A CONDITION IS DESCRIBED, DO NOT ASSUME THAT THE BULLETIN APPLIES TO YOUR VEHICLE, OR THAT YOUR VEHICLE WILL HAVE THAT CONDITION. SEE A GENERAL MOTORS DEALER SERVICING YOUR BRAND OF GENERAL MOTORS VEHICLE FOR INFORMATION ON WHETHER YOUR VEHICLE MAY BENEFIT FROM THE INFORMATION.
COPYRIGHT 1994 GENERAL MOTORS CORPORATION. ALL RIGHTS RESERVED.