TRACTION CONTROL SWITCH FALLS THROUGH SHIFTER TRIM PLATE

SUBJECT: TRACTION CONTROL SWITCH FALLS THROUGH SHIFTER TRIM PLATE AND INTO CENTER CONSOLE (INSTALL FELT TAPE)

MODELS: 1995 OLDSMOBILE AURORA

CONDITION:

SOME OWNERS MAY COMMENT ON THE TRACTION CONTROL ON/OFF SWITCH FALLING THROUGH THE SHIFTER TRIM PLATE INTO THE CENTER CONSOLE.

CAUSE:

A VARIATION IN SWITCH TO TRIM PLATE TOLERANCES MAY CAUSE THIS CONDITION.

CORRECTION:

1. REMOVE THE SHIFTER TRIM PLATE BY FOLLOWING THE PROCEDURE IN SECTION 8C OF THE SERVICE MANUAL.

2. RETRIEVE THE TRACTION CONTROL SWITCH FROM THE CENTER CONSOLE.

3. INSTALL FELT TAPE (AVAILABLE LOCALLY) ON SIDES OF TRACTION CONTROL SWITCH BELOW RETAINER TABS AS SHOWN IN THE ATTACHED ILLUSTRATION.

4. INSTALL TRACTION CONTROL SWITCH INTO SHIFTER TRIM PLATE AND VERIFY PROPER INSTALLATION.

5. INSTALL SHIFTER TRIM PLATE BY FOLLOWING THE PROCEDURES IN SECTION 8C OF THE SERVICE MANUAL.

WARRANTY INFORMATION:

FOR VEHICLES REPAIRED UNDER WARRANTY, USE:

LABOR OPERATION NUMBER: N2584 USE PUBLISHED LABOR OPERATION TIME.

FIGURES: 1

GENERAL MOTORS BULLETINS ARE INTENDED FOR USE BY PROFESSIONAL TECHNICIANS, NOT A "DO-IT-YOURSELFER". THEY ARE WRITTEN TO INFORM THOSE TECHNICIANS OF CONDITIONS THAT MAY OCCUR ON SOME VEHICLES, OR TO PROVIDE INFORMATION THAT COULD ASSIST IN THE PROPER SERVICE OF A VEHICLE. PROPERLY TRAINED TECHNICIANS HAVE THE EQUIPMENT, TOOLS, SAFETY INSTRUCTIONS AND KNOW-HOW TO DO A JOB PROPERLY AND SAFELY. IF A CONDITION IS DESCRIBED, DO NOT ASSUME THAT THE BULLETIN APPLIES TO YOUR VEHICLE, OR THAT YOUR VEHICLE WILL HAVE THAT CONDITION. SEE A GENERAL MOTORS DEALER SERVICING YOUR BRAND OF GENERAL MOTORS VEHICLE FOR INFORMATION ON WHETHER YOUR VEHICLE MAY BENEFIT FROM THE INFORMATION.

COPYRIGHT 1994 GENERAL MOTORS CORPORATION. ALL RIGHTS RESERVED.