Removal Procedure
- Disable the SIR system. Refer to
Disabling the SIR System
.
- Remove the connector position assurance (CPA) from the inflatable
restraint steering wheel module coil yellow 2-way connector at the base of
the steering column.
- Disconnect the inflatable restraint steering wheel module coil
yellow 2-way connector.
- Remove the upper and lower
steering column trim covers. Refer to
Steering Column Trim Cover Replacement - On Vehicle
in Steering Wheel
and Column-Tilt.
- Remove the inflatable restraint steering wheel module. Refer to
Steering Wheel Inflator Module Replacement
.
- Remove the steering wheel. Refer to
Steering Wheel Replacement
in Steering Wheel and Column-Tilt.
- Remove the wire harness straps from the steering wheel column
wire harness.
- Remove the retaining ring.
- Remove the inflatable
restraint steering wheel module coil from the steering shaft.
Installation Procedure
- Install the inflatable
restraint steering wheel module coil to the steering shaft.
- Install the retaining ring.
- Route the lower coil wire
harness along
steering column jacket.
- Install the wire harness straps to the steering wheel column wire
harness.
- Install the steering wheel. Refer to
Steering Wheel Replacement
in Steering Wheel and Column-Tilt.
- Install the inflatable restraint steering wheel module. Refer
to
Inflatable Restraint Steering Wheel Module Replacement
.
- Install the upper and lower steering column trim covers. Refer
to
Steering Column Trim Cover Replacement - On Vehicle
in Steering Wheel and
Column-Tilt.
- Connect the inflatable restraint steering wheel module yellow
2-way connector at the base of the steering column.
- Install the CPA to the inflatable restraint steering wheel module
coil yellow 2-way connector.
- Enable the SIR system. Refer to
Enabling the SIR System
.