Did you perform the Power Door Systems Diagnostic System Check?

--

Go to Step 2

Go to Diagnostic System Check - Power Door Systems

Verify that the side power door locks are inoperative.

Do the power door locks operate normally?

--

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step 3

1. Disconnect the side door lock actuator that is not functioning.
2. Inspect the connector terminals for looseness or damage.
3. Connect a test lamp to the actuator harness terminal A and terminal B.
4. Push a door lock switch to the lock or unlock position on the driver or passenger door.

Does the test lamp light?

--

Go to Step 7

Go to Step 4

Test CKT 295 (GRY) for an open. Refer to Circuit Testing in wiring systems.

Is an open present?

--

Go to Step 5

Go to Step 6

Repair the open in CKT 295 (GRY). Refer to Wiring Repairs in wiring systems.

Is the repair complete?

--

Go to Step 8

--

Repair the open in CKT 294 (TAN) or CKT 694 (TAN). Refer to Wiring Repairs in wiring systems.

Is the repair complete?

--

Go to Step 8

--

Replace the defective side door lock actuator. Refer to Door Lock Actuator Replacement

Is the repair complete?

--

Go to Step 8

--

Operate the system in order to verify the repair.

Did you correct the condition?

--

System OK

Go to Step 3