For 1990-2009 cars only
Removal Procedure
- Open the door.
- Remove the drip molding.
Installation Procedure
- Clean the area where the molding is to be mounted. Use a general purpose adhesive remover.
- Clean the affected body area with wax and grease remover, and wipe with isopropyl alcohol.
- Dry the area thoroughly.
- Ensure the body area is at a temperature range of 21-41°C (80-105°F).
- Ensure that the molding is at a temperature range of 21-41°C (80-105°F).
- Install end of seal beginning at the upper rear corner of front side door opening frame, towards the windshield reveal molding flange removing the tape backing as seal is applied.
- When seal is in position use a roller to firmly attach the tape to the entire contact surface.
Important: Apply the drip molding in an environment free of dust or dirt that could come in contact with the sticky backing and prevent proper adhesion.
