Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Did you perform the Body Control Module Diagnostic System Check? | -- | Go to Step 2 | Go to Diagnostic System Check - Body Control System in Body Control System |
2 | Did you review the audible warnings system operation and perform the necessary inspections? | -- | Go to Step 3 | |
3 | Verify that the lights on chime is inoperative. Is the chime operating properly? | -- | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 4 |
4 |
Is ON displayed? | -- | Go to Step 5 | Go to Step 8 |
5 | Inspect the connections at the BCM. Refer to Testing for Intermittent Conditions and Poor Connections Are the connections in need of repair? | -- | Go to Step 6 | Go to Step 7 |
6 | Repair the connections at the BCM as necessary. Refer to Connector Repairs in Wiring Systems. Is the repair complete? | -- | Go to Step 10 | -- |
7 | Replace the BCM. Refer to Body Control Module Replacement in Body Control System. Is the repair complete? | -- | Go to Step 10 | -- |
8 | Using a digital multimeter (DMM), backprobe and measure the voltage at BCM connector C2 terminal B6 to ground. Is battery voltage measured? | B+ | Go to Step 5 | Go to Step 9 |
9 | Locate and repair the open or high resistance in CKT 2409 between S283 and BCM connector C2 terminal B6. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Is the repair complete? | -- | Go to Step 10 | -- |
10 | Operate the system in order to verify the repair. Did you correct the condition? | -- | System OK | Go to Step 4 |
