Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Did you perform the Body Control Module Diagnostic System Check? | -- | Go to Step 2 | Go to Diagnostic System Check - Body Control System in Body Control System |
2 | Did you review the audible warnings system operation and perform the necessary inspections? | -- | Go to Step 3 | |
3 | Verify that the key-in-ignition chime is inoperative. Is the chime operating properly? | -- | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 4 |
4 |
Is YES displayed? | -- | Go to Step 5 | Go to Step 8 |
5 | Inspect the connections at the BCM. Refer to Testing for Intermittent Conditions and Poor Connections in Wiring Systems. Are the connections in need of repair? | -- | Go to Step 6 | Go to Step 7 |
6 | Repair the connections at the BCM as necessary. Refer to Connector Repairs in Wiring Systems. Is the repair complete? | -- | Go to Step 16 | -- |
7 | Replace the BCM. Refer to Body Control Module Replacement in Body Control Systems. Is the repair complete? | -- | Go to Step 16 | -- |
8 |
Is battery voltage displayed? | B+ | Go to Step 9 | Go to Step 14 |
9 |
Is battery voltage displayed? | B+ | Go to Step 10 | Go to Step 13 |
10 | Inspect for an open or high resistance in CKT 1850 between C211 and the ignition key alarm switch (CKT 80 and CKT 50). Refer to Circuit Testing in Wiring Systems. Was an open or high resistance found? | -- | Go to Step 11 | Go to Step 12 |
11 | Repair the open or high resistance in CKT 1850 between C211 and the ignition key alarm switch. Refer to Wiring Repairs in Wiring Systems. Is the repair complete? | -- | Go to Step 16 | -- |
12 | Replace the ignition key alarm switch. Refer to Ignition and Key Alarm Switch Assembly - Disassemble - Off Vehicle in Steering Wheel and Column - Standard or Ignition and Key Alarm Switch Assembly - Assemble - Off Vehicle in Steering Wheel and Column - Tilt. Is the repair complete? | -- | Go to Step 16 | -- |
13 | Locate and repair the open or high resistance in CKT 1850 between C211 and G207. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Is the repair complete? | -- | Go to Step 16 | -- |
14 | With a DMM connected to ground, backprobe the BCM connector C2 terminal B9 in CKT 80. Is battery voltage measured? | B+ | Go to Step 15 | Go to Step 5 |
15 | Locate and repair the open or high resistance in CKT 80 between BCM connector C2 terminal B9 and C211 terminal B3. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Is the repair complete? | -- | Go to Step 16 | -- |
16 | Operate the system in order to verify the repair. Did you correct the condition? | -- | System OK | Go to Step 4 |
