Circuit Description
When the supplemental restraint Sensing and Diagnostic Module (SDM) recognizes IGNITION 1 voltage, applied to terminal 10, is greater than 8.2 volts, the SDM flashes the AIR BAG warning lamp seven times to verify operation. At this time the SDM performs POWER-ON tests followed by the RESISTANCE MEASUREMENT test and the CONTINUOUS MONITORING tests. Upon detection of a malfunction, the SDM sets a current Diagnostic Trouble Code (DTC) and illuminates the AIR BAG warning lamp. The SDM will clear current DTCs and preserve them in a history file when:
| • | The malfunction is no longer detected. |
| • | The ignition switch is cycled. |
This does not include DTCs B1018, B1024, B1051, B1053, and B1071. DTCs B1018, B1024, B1051, B1053 are latched codes. You cannot clear a latched code. DTC B1071 may not clear after you issue a clear codes command.
Important: Repair the malfunction that set the DTC before you replace the SDM.
Test Description
The numbers below refer to the step numbers on the diagnostic table:
-
This test confirms a circuit malfunction. If no current malfunction is occurring (history DTC set), refer to the Diagnostic Aids for the appropriate DTC table as indicated through the scan tool. Do not replace the supplemental restraint sensing and diagnostic module (SDM) for a history DTC other than DTC B1071.
-
This test inspects for a malfunction introduced into the SRS during the diagnostic process. A malfunctioning SDM is unlikely to cause a new malfunction to occur during this process.
-
When you have found all circuitry outside the SDM to operate properly, as indicated by the appropriate diagnostic table, replace the SDM.
This table assumes that the SRS Diagnostic System Check or a Diagnostic Trouble Code table diagnosis has been performed. When all circuitry outside the supplemental restraint sensing and diagnostic module (SDM) has been found to operate properly, as indicated by the appropriate diagnostic table, and the symptom or DTC remains current, the following diagnostic procedures must be performed to verify the need for SDM replacement.
Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Were you sent here from a symptom table or a Diagnostic Trouble Code (DTC) table? | -- | ||
Does the AIR BAG warning lamp flash seven times then go OFF? | -- | |||
Use the Scan Tool in order to request the SRS DTC display. Is the same symptom or DTC occurring as when the SRS Diagnostic System Check was first performed? | -- | Go to the appropriate DTC table | ||
Does the AIR BAG warning lamp flash seven times then go OFF? | -- | System OK | ||
5 |
Has the SDM been replaced? | -- | -- | |
6 |
Have all the SRS components been reconnected and properly mounted? | -- | -- | |
7 | Clear the SRS DTCs. Have the SRS DTCs been cleared? | -- | -- |
