GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Isuzu 🢒 1998 🢒 S/T Isuzu - 2WD 🢒 Steering 🢒 Steering Wheel and Column - Standard 🢒 Steering Wheel Inflator Module Replacement

Removal Procedure

    Caution: Before servicing any electrical component, the ignition and start switch must be in the OFF or LOCK position and all electrical loads must be OFF, unless instructed otherwise in these procedures. If a tool or equipment could easily come in contact with a live exposed electrical terminal, also disconnect the negative battery cable. Failure to follow these precautions may cause personal injury and/or damage to the vehicle or its components.

  1. Disconnect the battery negative cable.
  2. Disable the SRS. Refer to Supplemental Inflatable Restraint Description .
  3. Turn OFF the ignition switch in order to unlock the steering wheel.

    4. Object Number: 288759 Size: SH
  4. Turn the steering wheel 90 degrees from the straight-ahead position in order to gain access to the access holes behind the steering wheel.

    5. Object Number: 288763 Size: SH
  5. Insert a screwdriver into each access hole and push the leaf spring in order to release the pin that retains the inflator module.
  6. Turn the steering wheel 180 degrees in order to gain access to the remaining access holes.
  7. Insert a screwdriver into each access hole and push the leaf spring in order to release the pin that retains the inflator module.
  8. Tilt the top of the inflator module rearward.
  9. Remove the SRS lead wire from the clip on the inflator module.
  10. Remove the SRS lead wire from the clip on the steering wheel.
  11. Remove the connector position assurance (CPA) retainer. Disconnect the electrical connector.
  12. Remove the inflator module from the vehicle.

Caution: When you are carrying an undeployed inflator module:

   • Do not carry the inflator module by the wires or connector on the inflator module
   • Make sure the bag opening points away from you
When you are storing an undeployed inflator module, make sure the bag opening points away from the surface on which the inflator module rests. When you are storing a steering column, do not rest the column with the bag opening facing down and the column vertical. Provide free space for the air bag to expand in case of an accidental deployment. Otherwise, personal injury may result.

Installation Procedure
  1. Connect the electrical connector. Install the CPA retainer.

    2. Object Number: 288768 Size: SH
  2. Connect the SRS lead wire to the clip on the steering wheel.
  3. Connect the SRS lead wire to the clip on the inflator module.
  4. Install the inflator module:
    5. • Firmly press the inflator module firmly on the steering wheel in order to engage and latch the four notched pins.
    • Do not pinch the SIR wires during the installation of the inflator module.
  5. Enable the SRS. Refer to Supplemental Inflatable Restraint Description .
  6. Connect the battery negative cable.