Upper Control Arm Bushings Replacement RWD

Tools Required

1. Remove the upper control arm from the vehicle. Refer to Upper Control Arm Replacement .
2. Mount the upper control arm in a vise.



3. Remove the washers and the nuts.



4. Remove the upper control arm bushings. Use the J22269-1 and the J21474-01.



5. Remove the upper control arm shaft from the control arm.

Tools Required

J 22269-1 Tie Rod End Installer

1. Install the control arm shaft into the upper control arm.
2. Install the control arm bushings into the upper control arm. Use the J 22269-1 .



3. Tighten the J 22269-1 .




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

4. Install the washers and the nuts.

Tighten
Tighten the nuts to 115 N·m (85 lb ft).

5. Install the upper control arm to the vehicle. Refer to Upper Control Arm Replacement .