Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

1

Access Panel Emblem

Tip

1. When removing protective liners from adhesive tape, be careful not to touch tape with hands and do not allow tape to come in contact with dirt or any foreign matter prior to adhesion.
2. Use a J 25070 Heat Gun - 500-750F or equivalent to remove the old emblem. Clean all adhesive from the forward access panel. Wipe surface dry with a clean lint-free towel prior to installing the new emblem.
3. Apply the new emblem with the cab in the closed position.
4. Apply pressure to the emblem to ensure full adhesion is made to the forward access panel.

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

1

Access Panel Emblem

Tip

1. When removing protective liners from adhesive tape, be careful not to touch tape with hands and do not allow tape to come in contact with dirt or any foreign matter prior to adhesion.
2. Use a J 25070 Heat Gun - 500-750F or equivalent to remove the old emblem. Clean all adhesive from the forward access panel. Wipe surface dry with a clean lint-free towel prior to installing the new emblem.
3. Apply the new emblem with the cab in the closed position.
4. Apply pressure to the emblem to ensure full adhesion is made to the forward access panel.

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

1

Access Panel Emblem

Tip

1. When removing protective liners from adhesive tape, be careful not to touch tape with hands and do not allow tape to come in contact with dirt or any foreign matter prior to adhesion.
2. Use a J 25070 Heat Gun - 500-750F or equivalent to remove the old emblem. Clean all adhesive from the forward access panel. Wipe surface dry with a clean lint-free towel prior to installing the new emblem.
3. Apply the new emblem with the cab in the closed position.
4. Apply pressure to the emblem to ensure full adhesion is made to the forward access panel.

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

1

Access Panel Emblem

Tip

1. When removing protective liners from adhesive tape, be careful not to touch tape with hands and do not allow tape to come in contact with dirt or any foreign matter prior to adhesion.
2. Use a J 25070 Heat Gun - 500-750F or equivalent to remove the old emblem. Clean all adhesive from the rear cab edge. Wipe surface dry with a clean lint-free towel prior to installing the new emblem.
3. Apply the new emblem with the cab in the closed position.
4. Apply pressure to the emblem to ensure full adhesion is made to the rear cab edge.