Removal Procedure
- Remove the right rear quarter trim panel. Refer to
Rear Quarter Trim Panel Replacement - Right Side
in Interior Trim.
- Disconnect the electrical connector from the air temperature actuator.
- Remove the retaining screws from the air temperature actuator.
- Remove the air temperature actuator (1)
from the rear HVAC module.
Installation Procedure
- Install the air temperature actuator (2)
to the rear HVAC module.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the screws to the actuator.
Tighten
Tighten the screws to 1.9 Nยทm (17 lb in).
- Connect the electrical connector to the air temperature actuator.
- Recalibrate the air temperature actuator. Refer to
Actuator Recalibration
.
- Install the right rear quarter trim panel. Refer to
Rear Quarter Trim Panel Replacement - Right Side
in Interior Trim.