For 1990-2009 cars only
Removal Procedure
- Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle.
- Remove the retainer.
- Disconnect the brake pipe line from the brake hose support bracket on the wheel housing on each side of the vehicle.
- Disconnect the brake hose from the C bracket on the steering knuckle shaft.
- Remove the bolt from the brake caliper.
- Remove the seal rings and the disc brake hose.
Installation Procedure
- Install the new disc brake hose to the caliper with new seal rings and the bolt and tighten to 40 N·m (30 lb ft).
- Slide the brake hose on the steering knuckle shaft C bracket.
- Connect the brake pipe line to the brake hose on the wheel housing bracket on each side of the vehicle and tighten to 16 N·m (12 lb ft).
- Lower the vehicle.
- Bleed the brake system. Refer to Hydraulic Brake System Bleeding.
- Inspect the brake system for leaks.
Caution: Refer to Fastener Caution in the Preface section.
