For 1990-2009 cars only
- Raise and support the vehicle.
- Remove the transaxle drain plug and allow the transaxle to drain completely.
- Remove the fluid level check plug.
- Clean and install the transaxle drain plug and tighten to 6 N·m (53 lb in) plus an additional 45-180 degrees.
- Add SAE75W90 transaxle fluid until it seeps out of the fluid level check plug.
- Clean and install the fluid level check plug and tighten to 6 N·m (53 lb in) plus an additional 45-180 degrees.
- Lower the vehicle and verify proper operation.
Warning: The transaxle fluid is hot. Caution must be taken to prevent personal injury when the transaxle fluid drains from the transaxle.
Caution: Refer to Fastener Caution in the Preface section.
Fluid Specification | SAE75W90 | |
|---|---|---|
Fluid Capacity | FWD | 2.1L (2.22 qt) |
