GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Holden 🢒 2009 🢒 Captiva 🢒 Safety and Security 🢒 Supplemental Inflatable Restraints 🢒 Roof Side Rail Inflatable Restraint Module Replacement

Removal Procedure

    Warning: Refer to Battery Disconnect Warning in the Preface section.

    Warning: The sensing and the diagnosis module (SDM) can maintain sufficient voltage to deploy the airbags and pretensioners for up to 1 minute after the ignition has been turned OFF and the fuse has been removed. If the airbags and pretensioners are not disconnected, do not begin service until one minute has been passed after disconnecting power to the SDM. Failure to do so may cause personal injury.

  1. Disable the supplemental inflatable restraints (SIR). Refer to SIR Disabling and Enabling.
  2. Remove the headliner. Refer to Headlining Trim Panel Replacement.

    3. Object Number: 1837444 Size: SH
  3. Remove the air bag module mounting bolts near the front and rear doors.
  4. Disconnect the roof rail air bag yellow electrical connector.

    5. Object Number: 1837446 Size: SH
  5. Remove the air bag module mounting bolts near the quarter window.
  6. Remove the roof rail air bag module.

Installation Procedure
  1. Install the roof rail air bag module.

    2. Caution: Refer to Fastener Caution in the Preface section.


    Object Number: 1837446 Size: SH
  2. Install the air bag module mounting bolts near the quarter window and tighten to 10 N·m (84 lb in).
  3. Connect the roof rail air bag yellow electrical connector.

    4. Object Number: 1837444 Size: SH
  4. Install the air bag module mounting bolts near the front and rear doors and tighten to 10 N·m (84 lb in).
  5. Install the headliner. Refer to Headlining Trim Panel Replacement.
  6. Enable the SIR. Refer to SIR Disabling and Enabling.