Scan Tool Data List. HUMMER H3 2006

For 1990-2009 cars only

Makes 🢒 HUMMER 🢒 2006 🢒 H3 🢒 Transmission/Transaxle 🢒 Manual Transmission - Aisin AR5 🢒 Scan Tool Data List

Use the scan tool data values under the following conditions:

•	The Diagnostic System Check - Vehicle is complete.

•	The on-board diagnostics (OBDs) are functioning properly.

•	No DTCs are present.

The values below represent a typical display recorded from a properly functioning system.

Important: Do not use a scan tool that displays faulty data. Report the condition to the scan tool manufacturer. The use of a faulty scan tool can result in misdiagnosis and the unnecessary replacement of parts.

Only the parameters listed below are used in this manual for diagnosing. If a scan tool displays other parameters, the values are not recommended by General Motors for use in diagnosis.

Scan tool values below were recorded under the following conditions:

•	Engine at idle

•	Upper radiator hose hot

•	Closed throttle

•	Transmission in Neutral

•	Closed Loop operation

•	Accessories OFF

•	Brake pedal not applied

Scan Tool Parameter

Data List*

Units Displayed

Typical Data Values

Vehicle Speed Sensor

1, 2, 4, 5, 6, 7, 8, 10, 11

km/h (mph)

*Data List Legend

•	Engine Data (1)

•	Evap Data (2)

•	Fuel Trim Data (3)

•	HO2S Data (4)

•	Ignition Data (5)

•	Misfire Data (6)

•	Cruise Control Data (7)

•	TAC Data (8)

•	Electrical/Theft Data (9)

•	HVAC Data (10)

•	IPC Data (11)