For 1990-2009 cars only
Removal Procedure
- Raise the vehicle. Refer to Lifting and Jacking the Vehicle.
- Remove the rear axle fill plug.
- Remove the rear axle drain plug.
- Drain the lubricant into a suitable container.
- Inspect the drain plug for excessive metal particle accumulation. This accumulation is symptomatic of extreme wear.
- Clean the drain plug.
Installation Procedure
- Install the rear axle drain plug and tighten to 33 N·m (24 lb ft).
- Fill the rear axle. Use the proper fluid. Refer to Approximate Fluid Capacities and Fluid and Lubricant Recommendations.
- Install the rear axle fill plug and tighten to 33 N·m (24 lb ft).
- Lower the vehicle.
Caution: Refer to Fastener Caution in the Preface section.
