The control on the driver's side of your instrument panel operates the exterior
lamps.
The exterior lamp control has four positions:
(Off): Turn the knob to this position to turn off all exterior
lamps including the DRL. This control will spring back to AUTO when released.
AUTO (Automatic): Turn the control to this position to put the
system into automatic headlamp mode. AUTO mode, if enabled, will turn the exterior
lamps, including your DRL, on and off automatically depending on how much light is
available outside the vehicle.
Your automatic lights may be
disabled even if the control is in the AUTO position.
To enable automatic lighting, do any of the following:
| • | Turn the headlamp control from AUTO to off and release the control. It
will return back to the AUTO position by itself. |
| • | Turn the headlamp control from the parking lamp position to AUTO. |
| • | Turn the headlamp control from the headlamp position to AUTO. |
| • | Turn your engine off and then on again with the headlamp control in AUTO. |
To disable automatic lighting, do any of the following:
| • | Turn the headlamp control from AUTO to off and release the control. It
will return back to the AUTO position by itself. |
| • | Turn the headlamp control from AUTO to the parking lamp position. |
| • | Turn the headlamp control from AUTO to the headlamp position. |
Turn the control to this position
to turn on the parking lamps, together with the following:
| • | Instrument Panel Lights |
Turn the control to this position to turn
on the headlamps, together with the previously listed lamps and lights.
When the vehicle is turned off and the headlamps are in AUTO, the headlamps may automatically
remain on for a set time. You can change this delay time using the DIC. See
Driver Information Center (DIC)
.
You can switch your headlamps from low to high-beam by pushing the turn signal/multifunction
lever toward the instrument panel.
