Removal Procedure
- Disable the SIR system. Refer to SIR Disabling and Enabling in SIR.
- Remove the Inflatable Restraint Steering Wheel module. Refer to Inflatable Restraint Steering Wheel Module Replacement in SIR.
- Remove the horn plunger from the steering column by pressing inward to the stop and rotating horn plunger 90 degrees.
- Disconnect the horn contact plate (2) captured screws (1,4) from the steering wheel (3).
- Remove the horn switch (2) from the steering wheel (3).
Caution: When performing service on or around the SIR components or the SIR wiring,
follow the procedures listed below in order to temporarily disable the SIR
system. Failure to follow the procedures could result in the following:
• Air bag deployment • Personal injury • Otherwise unneeded SIR system repairs
Installation Procedure
- Install the horn switch (2) to the steering wheel (3).
- Connect the horn contact plate (2) captured screws (1,4) to the steering wheel (3) .
- Install the horn plunger to the steering column.
- Install the inflator module. Refer to Inflatable Restraint Steering Wheel Module Replacement in SIR.
- Enable the SIR system. Refer to SIR Disabling and Enabling in SIR.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the screws to 5.5 N·m (50 lb in).
