Tools Required

Notice: Refer to Transfer Case Seal Removal Notice in the Preface section.




1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Remove the front propeller shaft from the vehicle. Refer to Front Propeller Shaft Replacement in Propeller Shaft.
3. Insert a flat-tipped screw driver in the inner race.
4. Pry the inner race forward.



5. Insert a small pry bar in the inner race.
6. Pry the inner part of the seal from the outer seal body.
7. Remove the inner part of the seal.



8. Insert a flat-tipped screw driver or small pry bar in the space between the outer race of the seal and the transfer case.
9. Pry the outer race out of the transfer case.
10. Remove the outer part of the seal.

1. Using the J 43484 (2) and the J 8092 (1), install the transfer case output seal.
2. Install the front propeller shaft. Refer to Front Propeller Shaft Replacement in Propeller Shaft.
3. Check the transfer case fluid level. Refer to Transfer Case Fluid Replacement .
4. Lower the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.