GM Service Manual Online
For 1990-2009 cars only
Makes
🢒
GMC_Truck
🢒
2000
🢒
Yukon - 2WD
🢒
Body and Accessories
🢒
Roof
🢒 Sunroof Drain Hose Replacement
Sunroof Drain Hose Replacement Rear
Removal Procedure
Remove the center pillar trim. Refer to
Center Pillar Garnish Molding Replacement
in Interior Trim.
Remove the headliner. Refer to
Headlining Trim Panel Replacement
.
Remove the drain hose from the nozzles rear, corner and side, assuring butyl tape is removed.
Remove the clip retaining hose to sheet metal.
Remove the grommet from the sealer plate.
Pull the hose away from sheet metal where attached with butyl tape.
Remove the hose.
Installation Procedure
Install the hose.
Re-locate the hose to sheet metal where attached with butyl tape.
Install the grommet to sealer plate.
Install the clip retaining hose to the sheet metal.
Install the hose to nozzles rear, corner and side, assure butyl tape is in position.
Install the headliner. Refer to
Headlining Trim Panel Replacement
in Interior Trim.
Install the center pillar trim. Refer to
Center Pillar Garnish Molding Replacement
in Interior Trim.
Sunroof Drain Hose Replacement Front
Removal Procedure
Remove the garnish molding/windshield pillar. Refer to
Windshield Pillar Garnish Molding Replacement
in Interior Trim.
Remove the sunshades. Refer to
Sunshade Replacement
in Interior Trim.
Pull down the corner of the headliner.
Remove the hose from module nozzle.
Remove the hose from the clip.
Remove the hose.
Installation Procedure
Install the hose.
Install the hose to clip.
Install the hose to module nozzle.
Be sure the seal is fully seated to plenum and hose is bottomed out against nozzle.
Inspect for kinks in the hose.
Push up the corner of headliner.
Install the sunshades. Refer to
Sunshade Replacement
in Interior Trim.
Install the garnish molding/windshield pillar. Refer to
Windshield Pillar Garnish Molding Replacement