Tools Required

1. Remove the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .
2. Remove the front propeller shaft. Refer to Front Propeller Shaft Replacement .
3. Insert a flat-tipped screwdriver into the inner race.
4. Pry the inner race back.



5. Insert a small pry bar into the inner race.



6. Remove the inner part of the seal.



7. Insert a flat-tipped screwdriver or a small pry bar in the space between the outer race of the seal and the transfer case.



8. Remove the outer part of the seal.

1. Install the J 43484 (2) to the J 8092 (1).
2. Install the seal onto the J 43484 (2).
3. Using the J 43484 (2) and the J 8092 (1), install the seal.
4. Install the front propeller shaft. Refer to Front Propeller Shaft Replacement .
5. Check the fluid level, add fluid if necessary.
6. Install the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .