Schematic Reference: Wiper/Washer Schematics

Did you review the Wiper/Washer System Description and Operation and perform the necessary inspections?

Go to Step 2

Go to Symptoms - Wiper/Washer Systems

1. Turn the ignition ON.
2. Turn the windshield wiper/washer switch to the OFF position.

Do the windshield wipers remain in the park position?

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step 3

1. Turn the ignition OFF.
2. Disconnect the inline harness connector C200.
3. Remove the connector terminal row E from the steering column harness connector half.
4. Connect the inline harness connector C200.
5. Turn the ignition ON.

Are the windshield wipers always on?

Go to Step 4

Go to Step 6

1. Disconnect the windshield wiper motor connector.
2. Test the windshield wiper switch low circuit for a short to voltage. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 7

Go to Step 5

Replace the windshield wiper motor module. Refer to Wiper Motor Cover Replacement .

Is the repair complete?

Go to Step 7

--

Replace the windshield wiper/washer switch. Refer to Multifunction, Turn Signal, and Hazard Switch Replacement - On Vehicle in Steering Wheel and Column.

Is the repair complete?

Go to Step 7

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 3