Disassembly Procedure
Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:
• | Unnecessary SIR system repairs |
In order to avoid the above conditions, observe the following guidelines:
• | Refer to SIR Component Views in order to determine if you are performing service on or near the SIR components or the SIR wiring. |
• | If you are performing service on or near the SIR components or the SIR wiring, disable the SIR system. Refer to Disabling the SIR System. |
- Disable the inflatable restraint steering
wheel module. Refer to
Disabling the SIR System
in SIR.
- Remove the upper and lower trim covers. Refer to
Steering Column Trim Covers - Disassemble - Off Vehicle
.
- Remove the wire harness assembly (4) out of the wire harness
strap (5).
Remove the wire harness straps (3) from the wire harness assembly (4).
Remove the wire harness strap (2) from the upper tilt head assembly (1).
- Remove the inflatable
restraint steering wheel module coil from the steering shaft assembly using
the following steps:
4.1. | The retaining ring (1). |
4.2. | The inflatable restraint steering wheel module coil (2). |
4.3. | The wave washer (3). |