For 1990-2009 cars only
Removal Procedure
- Disconnect the cable from the primary latch:
- Remove the cable from the fasteners in the radiator support.
- Remove the cable grommet from the cowl.
- Disconnect the cable from the cowl.
- Remove the left cowl side trim panel. Refer to Cowl Side Trim Panel Replacement .
- Pull the cable through the cowl in order to remove the screws that retain the cable assembly to the cowl side panel.
| 1.1. | Place a screwdriver into the cable clip in order to pry the cable clip open and remove the cable. |
| 1.2. | Pry the cable housing from the latch. |
Installation Procedure
- Route the cable through the instrument panel through the front of the cowl and under the power brake booster hose.
- Install the screws that retain the cable to cowl side panel.
- Install the left cowl side trim panel. Refer to Cowl Side Trim Panel Replacement .
- Pull the cable assembly from the front of the cowl until the grommet is seated.
- Connect the cable to the fasteners in the radiator support.
- Use a suitable tool in order to clamp the cable clip and connect the cable to the primary latch.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the screws that retain the cable to cowl side pane to 2 N·m
(18 lb in).
