GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 1998 🢒 Safari - 2WD 🢒 Body and Accessories 🢒 Instrument Panel, Gauges, and Console 🢒 Fasten Safety Belt Chime Always On

Step

Action

Value(s)

Yes

No

1

Did you perform the Audible Warning System Check?

--

Go to Step 2

Go to Audible Warnings System Check

2
  1. Place the ignition switch in the OFF or the LOCK position.
  2. Unfasten the left hand safety belt.

Is the fasten safety belts warning alarm present?

--

Go to Step 6

Go to Step 3

3

Fasten the LH safety belt.

Is the fasten safety belts warning alarm present?

--

Go to Step 4

Go to Step 5

4

Replace the audio alarm module. Refer to Multifunction Alarm Module Replacement .

Is the repair complete?

--

Go to Audible Warnings System Check

--

5

Place the ignition switch in the RUN position.

Is the fasten safety belts warning alarm present?

Go to Step 9

Go to Audible Warnings System Check

6
  1. Remove the audio alarm module from the convenience center.
  2. Connect a DMM J 39200 from the convenience center cavity K1 to ground.

Is there battery voltage?

--

Go to Step 7

Go to Step 8

7

Repair the short to voltage in CKT 238 (BLK/WHT) between the instrument panel fuse block and the convenience center.

Is the repair complete?

--

Go to Audible Warnings System Check

--

8

Replace the audio alarm module. Refer to Multifunction Alarm Module Replacement .

Is the repair complete?

--

Go to Audible Warnings System Check

--

9
  1. Remove the audio alarm module from the convenience center.
  2. Use a DMM J 39200 in order to test for continuity from the convenience center cavity K1 to ground.

Is there continuity?

--

Go to Step 11

Go to Step 10

10

Replace the audio alarm module. Refer to Multifunction Alarm Module Replacement

Is the repair complete?

--

Go to Audible Warnings System Check

--

11
  1. Disconnect the safety belt retractor switch connector.
  2. Disconnect the connector at the inflatable restraint sensing diagnostic module.
  3. Use a DMM J 39200 in order to test for continuity from the convenience center cavity K1 to ground.

Is there continuity?

--

Go to Step 12

Go to Step 13

12

Repair the short to ground in CKT 238 (BLK/WHT) between the following components:

    • The convenience center
    • The inflatable restrains sensing diagnostic module
    • The safety belt retractor switch

Is the repair complete?

--

Go to Audible Warnings System Check

--

13
  1. Reconnect the inflatable restrains sensing diagnostic module.
  2. Use a DMM J 39200 in order to test for continuity from the convenience center cavity K1 to ground.

Is there continuity?

--

Go to Step 14

Go to Step 15

14
  1. Test the inflatable restraint sensing diagnostic module. Refer to SIR Diagnostic System Check .
  2. Replace the inflatable restraint sensing diagnostic module. Refer to Inflatable Restraint Sensing and Diagnostic Module Replacement in Restraints.

Is the repair complete?

--

Go to Audible Warnings System Check

--

15

Replace the seat belt buckle switch. Refer to Front Seat Belt Buckle Replacement in Seatbelts.

Is the repair complete?

--

Go to Audible Warnings System Check

--