Under-inflated tires

Inflate the tires to the specified pressure. Refer to Tire Inflation Pressure Specifications .

The lower coupling flange is rubbing against the steering gear adjuster plug.

Loosen the pinch bolt and assemble properly.

The steering wheel is rubbing against the directional signal housing.

Adjust the steering wheel jacket. Refer to Steering Shaft Lower Bearing Jacket - Disassemble/Assemble.

Tight or frozen steering shaft bearings

Replace the bearings.

Binding in the steering linkage

Replace any affected components. Refer to Ball Joint Wear Check in Front Suspension.

Misalignment of the steering gear to the column

Align the steering column.

A lack of lubrication in the suspension ball joints and the steering linkage

Lubricate the suspension joints and the steering linkage. Refer to Steering Linkage Inspection in Steering Linkage.

Stuck or plugged steering gear valve spool

Replace the steering gear.

Improper front wheel alignment

1. Inspect the alignment of the front wheels.
2. Adjust the alignment to specifications. Refer to Wheel Alignment Specifications .

A kink in the return hose

Replace the return hose.

The rubber spacer is binding in the shift tube.

Ensure that the spacer is properly seated. Lubricate the inside the diameter with silicone lubricant.

The steering gear is adjusted to tightly.

Adjust the over-center and thrust bearing preload to specifications. Refer to Steering Gear Pitman Shaft Over-Center Preload Adjustment - Off Vehicle .

The steering intermediate shaft stone shield is side-loaded against the shaft assembly.

Eliminate the side-load.