GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 2005 🢒 Envoy - 4WD 🢒 Body 🢒 Wipers/Washer Systems 🢒 Endgate Window Replacement

Removal Procedure
  1. Lower the endgate window approximately halfway down.
  2. Swing the endgate open.
  3. Remove the endgate window outer sealing strip. Refer to Endgate Window Outer Sealing Strip Replacement .
  4. Remove the endgate trim panel. Refer to Endgate Trim Panel Replacement .
  5. Remove the inner reinforcement panel. Refer to Endgate Inner Panel Reinforcement Replacement .

    6. Object Number: 902609 Size: SH
  6. Disconnect the electrical connectors from the defogger grid on the window.
  7. Remove the bolts (2) retaining the endgate window clips (1) to the regulator carrier plates.
  8. Remove the window from the endgate.

Installation Procedure

    Object Number: 902609 Size: SH
  1. Install the endgate window to the endgate. Ensure the window is engaged in the run channels.
  2. Install the window clips (1) down onto the regulator carrier plates.

    3. Notice: Refer to Fastener Notice in the Preface section.

  3. Install the bolts (2) retaining the window to the regulator carrier plates.

    4. Tighten
    Tighten the window bolts to 12 N·m (106 lb in).

  4. Connect the electrical connectors to the defogger grid on the endgate window.
  5. Install the inner reinforcement panel. Refer to Endgate Inner Panel Reinforcement Replacement .
  6. Install the interior trim panel. Refer to Endgate Trim Panel Replacement .
  7. Install the endgate window outer sealing strip. Refer to Endgate Window Outer Sealing Strip Replacement .