Warning messages are displayed on the DIC to notify the driver that the status of the vehicle has changed and that some action may be needed by the driver to correct the condition. More than one message may appear at one time. They will appear one behind the other. Some messages may not require immediate action but you should press the trip stem to acknowledge that you received the message and clear it from the display. Pressing any of the DIC steering wheel buttons -- trip information, fuel information, customization or select button -- will also acknowledge any warnings or service messages. Some messages cannot be cleared from the display because they are more urgent. These messages require action before they can be removed from the DIC display. The following are the possible messages that can be displayed and some information about them.

If the battery is not charging during operation, this message will appear on the DIC. Driving with this problem could drain your battery. Have the electrical system checked by your GM dealer as soon as possible. See Voltmeter Gage . Pressing the select button will acknowledge this message and clear it from the DIC display.

If the washer fluid level is low, this message will appear on the DIC. Adding washer fluid will clear the message. See Windshield Washer Fluid . Pressing the select button will acknowledge this message and clear it from the DIC display.

One or more obstacles are preventing the roof request from being performed. Check the roof for any obstacles. See Power Roof for more information.

The roof must be fully opened or fully closed while the vehicle is in motion. See Power Roof for more information.

The roof must be closed to enable future roof and/or tailgate operations. See Power Roof for more information.

The tailgate must be closed to operate the tailgate glass. See Tailgate .

The curb view activated message is displayed when the passenger outside rearview mirror moves into the curb view position. See Outside Curb View Assist Mirror for more information.

If the driver's door is not fully closed, this message will appear on the display and you will hear a chime. Stop and turn off the vehicle, check the door for obstacles, and close the door again. Check to see if the message still appears on the DIC. Pressing the select button will acknowledge this message and clear it from the DIC display.

If the cooling system temperature gets hot, this message will appear in the DIC and you will hear a chime. See Engine Overheating for the proper course of action. This message will clear when the coolant temperature drops to a safe operating temperature.

If the fuel level is low in the vehicle's gas tank this message will appear on the DIC and you will hear a chime. Refuel as soon as possible. Pressing the select button will acknowledge this message and clear it from the DIC display. See Low Fuel Warning Light , Filling the Tank and Fuel for more information.

If the outside temperature reaches a level where ice could form on the roadway, this message may appear on the DIC. If the temperature rises to a safe level, the message will clear. Pressing the select button will acknowledge this message and clear it from the DIC display.

If a remote keyless entry transmitter battery is low, this message will appear on the DIC. The battery needs to be replaced in the transmitter. See "Battery Replacement" under Remote Keyless Entry (RKE) System Operation . Pressing the select button will acknowledge this message and clear it from the DIC display.

If the driver's side rear door is not fully closed this message will appear on the display and you will hear a chime. Stop and turn off the vehicle, check the door for obstacles, and close the door again. Check to see if the message still appears on the DIC. Pressing the select button will acknowledge this message and clear it from the DIC display.

If low oil pressure levels occur, this message will be displayed on the DIC. Stop the vehicle as soon as safely possible and do not operate it until the cause of the low oil pressure has been corrected. Check your oil as soon as possible and have your vehicle serviced by your GM dealer. See Engine Oil .

Notice: If you drive your vehicle while the engine oil pressure is low, severe engine damage may occur. If a low oil pressure warning appears on the Driver Information Center (DIC), stop the vehicle as soon as possible. Do not drive the vehicle until the cause of the low oil pressure is corrected. See Engine Oil for more information.

The roof must be opened to enable future roof and/or tailgate operations. See Power Roof and Tailgate .

Stop the vehicle and shift into PARK (P) to operate the roof. See Power Roof .

If the passenger's door is not fully closed, this message will appear on the display and you will hear a chime. Stop and turn off the vehicle, check the door for obstacles, and close the door again. Check to see if the message still appears on the DIC. Pressing the select button will acknowledge this message and clear it from the DIC display.

Check the rear wiper. An object is preventing it from moving to the off position. Tailgate glass operations cannot be performed if the rear wiper is not in the off position. See Windshield Wiper Blade Replacement .

If the passenger's side rear door is not fully closed this message will appear on the display and you will hear a chime. Stop and turn off the vehicle, check the door for obstacles, and close the door again. Check to see if the message still appears on the DIC. Pressing the select button will acknowledge this message and clear it from the DIC display.

The roof is closed and latched. See Power Roof for more information.

The roof is moving in the closed direction. See Power Roof for more information.

The roof is moving in the opened direction. See Power Roof for more information.

The roof is opened and stowed. See Power Roof for more information.

If there is a problem with the airbag system this message will be displayed on the DIC. Have your GM dealer inspect the system for problems. See Airbag Readiness Light and Airbag System for more information. Pressing the select button will acknowledge this message and clear it from the DIC display.

If a problem occurs with the brake system this message will appear on the DIC. If this message appears, stop as soon as possible and turn off the vehicle. Restart the vehicle and check for the message on the DIC display. If the message is still displayed, or appears again when you begin driving, the brake system needs service. See your GM dealer.

The tailgate is ajar and should be closed before moving the vehicle. See Tailgate for more information.

The rear wiper/defog request cannot be performed because the tailgate glass is down. See Tailgate and Windshield Washer for more information.

The tailgate is in drop mode. Operate the vehicle with caution. See Tailgate for more information.

The window position needs to be reset. Activate the tailgate window up switch and continue to hold it for two seconds after the window is fully closed. Then activate the tailgate window down switch and continue to hold it for two seconds after the window is fully open. See Tailgate . If this process does not restore the tailgate function, see your GM dealer for service.

If the vehicle's fuel cap is not tightened properly, this message may appear on the DIC and a chime will sound. Fully reinstall the fuel cap. See Filling the Tank . The diagnostic system can determine if the fuel cap has been left off or improperly installed. A loose or missing fuel cap will allow fuel to evaporate into the atmosphere. The DIC message will remain on until the message is cancelled with the return button on the steering wheel. The DIC message will also be cancelled if the ignition is turned off.

The DIC message and the Service Engine Soon light may come on again during a second trip if the fuel cap is still not tightened properly. See Malfunction Indicator Lamp for more information.

If a turn signal is left on for 3/4 of a mile (1.2 km), this message will appear on the display and you will hear a chime. Move the turn signal/multifunction lever to the off position. Pressing the select button will acknowledge this message and clear it from the DIC display.