Removal Procedure
- Disconnect the electrical connector from the mass air flow (MAF)/intake air temperature
(IAT) sensor.
- Remove the 2 screws securing the MAF/IAT sensor to the air cleaner assembly.
- Remove the MAF/IAT sensor from the air cleaner assembly.
Installation Procedure
Notice:
ā¢ | Handle the MAF sensor carefully. |
ā¢ | Do not drop the MAF sensor in order to prevent damage to the MAF
sensor. |
ā¢ | Do not damage the screen located on the air inlet
end of the MAF. |
ā¢ | Do not touch the sensing elements. |
ā¢ | Do not allow solvents and lubricants to come in contact with the
sensing elements. |
ā¢ | Use a small amount of a soap based solution in order to aid in
the installation. |
- Insert the MAF/IAT sensor into the air cleaner assembly.
Notice: Refer to Fastener Notice in the Preface section.
- Install the 2 screws securing the MAF/IAT sensor to the air cleaner assembly.
Tighten
Tighten the MAF/IAT sensor screws to 2.25 NĀ·m (20 lb in).
- Connect the electrical connector to the MAF/IAT sensor.