GM Service Manual Online
For 1990-2009 cars only
Makes
🢒
GMC_Truck
🢒
2007
🢒
Acadia - AWD
🢒
Engine
🢒
Engine Controls and Fuel - 3.6L
🢒 Engine Support Fixture
Installation Procedure
Special Tools
•
J 28467-B
Universal Engine Support Fixture
•
J 28467-7A
Bolt Hook
•
J 28467-34
Lift Hook Wing Nut and Washer
•
J-41803-9
Engine Lift Hook
•
J 42451-1
Engine Support Adapter
Remove the injector sight shield. Refer to
Fuel Injector Sight Shield Replacement
.
Remove the underhood electrical center. Refer to
Underhood Electrical Center or Junction Block Replacement
.
Remove the right engine strut mount. Refer to
Engine Mount Strut Replacement - Right Side
.
Install the
J 42451-1
to the right side of the engine.
Install the
J-41803-9
to the left side front of the engine.
Using
J 28467-B
, install the ends of the strut tower tube J 28467-518 (1) to the engine support adapter legs (P/N) 48059 (2).
Place the strut tower tube J 28467-518 and the (P/N) 48059 on top of both the left and right fender lips, over the engine rear lift bracket.
Install the radiator shelf tube J 36462-1A (2) on top of the strut tower tube J 28467-518 (1) above the left side of the engine.
Install the round tube of the front support assembly J 28467-4A through the large hole in the radiator shelf tube J 36462-1A.
Remove the upper tie bar cover.
Locate the J 28467-4A front support assembly to the upper tie bar.
Install the J 28467-9 quick-release pin through the bottom hole in the J 28467-4A front support assembly.
Install the J 28467-9 quick-release pin through the hole above the J-36462-1A radiator shelf tube.
Install the J 28467-1A cross bracket assembly.
Hand tighten the J 28467-1A cross bracket wing nuts.
Install the
J 28467-7A
bolt hook through the
J-41803-9
bracket.
Install the
J 28467-34
lift hook wing nut and washer to the
J 28467-7A
lift hook.
Repeat the previous 2 steps in order to assemble 2 lift hooks and brackets.
Install one of the lift hook and bracket assemblies (1) to the J 28467-518 strut tower tube (2) above the
J 42451-1
engine rear lift bracket.
Install the lift hook
J 28467-7A
through the
J 42451-1
engine rear lift bracket. Ensure the hook does not damage adjacent components.
Install the other lift hook and bracket assembly (1) to the J 28467-2A radiator shelf tube (2) above the engine front lift bracket.
Install the lift hook
J 28467-7A
through the
J-41803-9
engine front lift bracket. Ensure the hook does not damage adjacent components.
Hand tighten the lift hook wing nuts
J 28467-34
in order to remove all slack from the engine support fixture assembly.