For 1990-2009 cars only
Removal Procedure
- Disable the SIR System. Refer to SIR Disabling and Enabling.
- Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
- Remove all related panels and components.
- Visually inspect the damage. Repair as much of the damage as possible.
- Remove the sealers and anti-corrosion materials from the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair.
- Locate and mark all factory welds.
- Drill all factory welds. Note the number and location of welds for installation of the service assembly.
- Cut the adhesive with an appropriate tool.
- Remove the damaged roof panel (1).
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section.
Installation Procedure
- Drill 8 mm (5/16 in) for plug welding along the edges of the service panel as noted from the original panel.
- Clean and prepare the attaching surfaces for welding.
- Apply one-part windshield urethane adhesive as noted from the original panel.
- Position the roof panel on the vehicle.
- Verify the fit of the panel.
- Clamp the panel into position.
- Plug weld accordingly.
- Apply the sealers and anti-corrosion materials to the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair.
- Paint the repaired area. Refer to Basecoat/Clearcoat Paint Systems.
- Install all related panels and components.
- Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
- Enable the SIR system. Refer to SIR Disabling and Enabling.
